BBQGrillRepair.center (844) 660-6426Mon–Sat, 8am–8pm Book a visit
The inside wall of an open pellet grill on a patio, a thin steel temperature sensor mounted near the grill's cooking grate, a meat probe lead resting on the side shelf beside it.

Weber E5: the pellet grill is running too hot

The controller compares the cookbox reading with the set temperature and stops feeding pellets when heat runs away.

(844) 660-6426

Mon–Sat, 8am–8pm

  • Temperature and probes
  • Pellet grill auger and controller repair
  • Source: Weber

Book a visit

Three short steps, about a minute.

or call (844) 660-6426

What E5
actually means.

The controller compares the cookbox reading with the set temperature and stops feeding pellets when heat runs away. On a pellet grill the usual cause is grease and ash that have caught fire in the cookbox or grease tray, which is why Weber's fix starts with cleaning.

Weber grill display

What to do when E5 shows on the grill

Kind of codeTemperature and probes

A probe is sending the controller a reading it cannot trust, or no reading at all: the grill's own temperature sensor coated in smoke and grease, its lead pinched or melted, or a meat probe unplugged, wet or reading far outside what any cook box could reach. The grill then overshoots, stalls or shuts down to be safe. Wiping the sensor once the grill is cold and reseating the probe in its jack are reasonable steps; a sensor that still reads wrong is a visit.

Usually leads toPellet grill auger and controller repair

Jammed augers, dead hot rods, weak combustion fans, lying probes and failed controllers on pellet grills, traced and replaced with the maker's parts.

Shows up asGrill Error Code on a Pellet Controller or Digital Panel

A grill error code shows as letters and numbers on a pellet grill controller, a flashing light on a digital control panel, or an alert in the maker's app paired with the grill.

MakeWeber

Weber grill calls often come from a flame that dropped low mid-cook; the tech starts at the tank, the hose and the regulator.

SourceWeber Searwood 600 / XL 600 owner's guide (US, 2024), troubleshooting pages

Searwood 600 and Searwood XL 600 pellet grills with the Weber Connect digital controller (US owner's guide, 2024). SmokeFire grills use E5 for the same overheat shutdown.

Before you book,
in this order.

Each step comes from Weber's own guidance for E5 on its grills. Follow it to the end: the last card says whether this is a visit.

01

Keep the lid closed so the fire starves of air, and let the shutdown cycle run; never use water on a grease fire.

02

If flames keep growing or spread beyond the grill, move away and call 911.

03

When the grill is completely cold, clean the burn pot, cookbox and grease tray and replace the drip pan.

04

Look the grill over for heat damage, and book a visit if E5 comes back on a clean grill.

Still there?

It usually turns into pellet grill auger and controller repair. Book with the code and the model number.

What not to do

E5 is not a probe reading from your food; meat probe trouble is E17. Heat that falls away instead of rising is E18.

What you may
notice with it.

The grill problems E5 tends to arrive with. Answer these at the grill before anyone is booked.

All problems

Before you call

Grill Error Code on a Pellet Controller or Digital Panel

All 7 causes, cheapest first

It also comes with

Close view of the small dark digital controller on the side of a pellet grill hopper, one abstract amber indicator glowing beside unlit segments, the grain of a patio table blurred behind. Problem

Grill Error Code on a Pellet Controller or Digital Panel

7 causes, cheapest first

Where E5 usually leads

Pellet grill auger and controller repair.

Auger clearing, auger motor, hot rod, combustion fan, probe or controller on a pellet grill · moderate.
Book a visit What the job involves

Weber
grills.

Weber grill calls often come from a flame that dropped low mid-cook; the tech starts at the tank, the hose and the regulator.

Weber grill repair

More Weber codes

E1E2E3E4E6E7E8E9E10E11E17E18
All 15 Weber codes

Temperature and probes on other makes

Broil King Warning iconFire Magic ErrLynx Burner N cannot reach target temperatureTwin Eagles Knob bezel yellow, orange or redCoyote Overheat Alarm
All 11 codes of this kind
A large stainless built-in gas grill head set into a stone island on a sunny patio, its hood raised to show three burners glowing with even blue flame under clean stainless grates, the knob panel below with knobs, the access doors under the grill closed, plants softly blurred behind, daylight, seasonless. Weber builds this

Built-in gas grill

A stainless grill head dropped into a masonry or steel island, fed by a tank or the house gas line, with its burners, knobs and lid working in open weather.

 A stainless freestanding gas grill on a four-wheeled cart standing on a clean stone patio, its hood open over bare stainless grates with a soft blue burner glow beneath, side shelves folded out and empty, the cabinet doors below closed, a lawn and shrubs softly blurred behind, daylight, seasonless. Weber builds this

Freestanding gas grill

A gas grill on its own cart with wheels, side shelves and a propane tank below, or a hose to a house gas outlet, rolled into place on the patio.

 Close view of an open stainless grill with one infrared sear burner glowing bright orange across its honeycombed ceramic face under a heavy stainless grate, blue-flame burners beside it, the grill's hood raised on a patio, background softly blurred, daylight, seasonless. Weber builds this

Infrared grill

Grills that cook with radiant heat: ceramic or mesh infrared burners, sear stations beside the main burners, and radiant glass or emitter plates over a gas flame.

In Weber's own words

E5 - Grill Too Hot
Weber Searwood 600 / XL 600 owner's guide (US, 2024), troubleshooting pages Weber Searwood 600 / XL 600 owner's guide (US, 2024), troubleshooting pages Weber help center, SmokeFire error code article (E5) Weber Searwood 600 / XL 600 owner's guide (US, 2024), troubleshooting pages

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Searwood 600 and Searwood XL 600 pellet grills with the Weber Connect digital controller (US owner's guide, 2024). SmokeFire grills use E5 for the same overheat shutdown.

Weber E5 grill repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas

Tampa BayFL · 31 areas

OrlandoFL · 30 areas

Miami / South FloridaFL · 47 areas

New York MetroNY · 75 areas

HoustonTX · 36 areas

ChicagoIL · 50 areas

Los AngelesCA · 95 areas

San DiegoCA · 31 areas

San Francisco Bay AreaCA · 74 areas

A family gathered around a grill on a sunny patio.
For the heart of your home.

Questions
about E5.

Can I clear E5 myself?
Keep the lid closed so the fire starves of air, and let the shutdown cycle run; never use water on a grease fire. If it comes back, it needs a visit.
Why did my Weber Searwood show E5 during a high-heat sear?
Grease left from earlier low-temperature cooks can ignite once the grill climbs to searing heat. Weber suggests extra cleaning after low and slow cooks before a hot one for that reason.
Should I open the lid when my Weber shows E5?
Weber's instruction for E5 is to keep the lid closed during the shutdown. Opening it feeds air to any fire burning inside.
Is my Weber safe to use again after an E5?
Clean it fully and inspect it for warped or scorched parts first. If the code returns on a clean grill, have the temperature sensor and controller checked before cooking again.

Back to your everyday

Still showing E5?

A booking with a code goes further when it has the code copied exactly, the model and serial from the rating label, and a word on whether the grill still lights, heats or feeds pellets. With those three the office can match the likely part to your grill the same day.

Schedule a repair Call (844) 660-6426
(844) 660-6426 Schedule a repair